B&D Firmadoor Series Installation Instructions Manual - page 6
PART NO: 51621. REVISION 6 - OCTOBER 2016
1.6 parts checklist
120mm
10
-
7
5m
m
Line for Edge of Door Curtain
(Check this measurement if an
opener is to be fitted)
230mm Restricted or
250mm Normal Headroom
A
B
C
E
D
F
G
H
I
J
K
J
K
315mm Restricted or
350mm Normal
DON’T CUT THE PLASTIC
L
M
N
O
P
Q
A. 1 - rolled, plastic wrapped door
B. 2 - “A” style brackets, left and right
handed
C. 2 - door guides, left and right handed
D. 2 - steel locking bars
1 small parts bag containing:
E. 4 to 10 - guide clips
F. 2 - metal stops
G. 1 - faceplate and lock assembly 2 - keys
H 2 - locking bar retainer
I.
2 - locking bar covers
J. 2 - “U” bolts
K. 2 - axle/bracket saddles
L. 4 - 8mm nuts and washer for “U” bolts
M. 2 - counter sunk screws for handle
N. 2 - 7mm x 4mm mushroom head screws
O. 2 - 4mm x 6mm locking bar screws
P. 4 - 10mm washers
Q. 8 to 12 - 8mm washers
1.5 tools checklist
A professorial installers tool kit is required to install the door. You will also need assistance to help you lift the door up
safely and carry out some other steps.
Coach screws are supplied with the door for fitting to timber. Correct and safe fastening to other materials may
require different fasteners. The installer must select and use fasteners appropriate to the material into which they
are being fixed.
NOTE: It is the installer’s responsibility to ensure that the fixing methods are sound.
1.4 fixing requirements
6
Firmadoor
®
Series 1 Installation Instructions