B&D Firmadoor Series Installation Instructions Manual - page 9
PART NO: 51621. REVISION 6 - OCTOBER 2016
To attach metal stops to bottom rail of door.
a) Hook stop behind lip in rail, as shown.
b) Secure from underneath the rail with screws
supplied. You will need to trim the weatherseal
flush with the end of the bottom rail.
1
WOOD CHOCK
ROLL-A-GUIDE
RESTRICTED HEADROOM 35mm
SPACE
EVENLY
GUIDE
CLEARANCE
0>1mm
GUIDE BLOCK
200mm
DOOR
CURTAIN
BOTTOM RAIL
BOTTOM RAIL LIP
STOP
(a)
(a)
(b)
(c)
(e)
(d)
(b)
2
FIRST PREPARE A SOFT WOOD CHOCK,
ABOUT 400mm LONG.
THEN - Ensure that bottom rail is at the 3 o’clock
position as shown in Step 4 - if not, refer to Step 2.4.
a) Ensure both “U” bolts are tightened, then -
1. Rotate the door 1½ turns in a forward direction
to apply tension. Do not let go as the springs
are now tensioned. See arrow in Fig (a).
2. Hold the door firmly,
NOW cut the plastic
wrap along the bottom rail (taking care not to
damage door surface or weatherseal).
b) Pull the curtain down slowly and carefully position
the wooden chock (or other appropriate stop) as
shown in Fig (b). Take care not to damage door
surface.
The chock will help hold the door until the guides and
stops are fitted.
1
WOOD CHOCK
ROLL-A-GUIDE
RESTRICTED HEADROOM 35mm
SPACE
EVENLY
GUIDE
CLEARANCE
0>1mm
GUIDE BLOCK
200mm
DOOR
CURTAIN
BOTTOM RAIL
BOTTOM RAIL LIP
STOP
(a)
(a)
(b)
(c)
(e)
(d)
(b)
2
1
WOOD CHOCK
ROLL-A-GUIDE
RESTRICTED HEADROOM 35mm
SPACE
EVENLY
GUIDE
CLEARANCE
0>1mm
GUIDE BLOCK
200mm
DOOR
CURTAIN
BOTTOM RAIL
BOTTOM RAIL LIP
STOP
(a)
(a)
(b)
(c)
(e)
(d)
(b)
2
2.6 attaching stop
2.5 tension the springs
9
Firmadoor
®
Series 1 Installation Instructions