B-Tech Quintro + User Manual - page 9
9
4. Depress the LOCK key once to turn
on the LOCK function to prevent
recording from interruption. All
lamps will change from green to
orange.
5. Depress the RECORD key on your
VCR and the PLAY key on the
video source equipment. Recording
will start.
RGB or S-video format can
be recorded on “SCART 1”.
To watch the output from another
device while recording?
i
You may select another input,
recording will not be interrupted.
ii
The lamp of the newly selected
input will turn on in green.
iii
The lamps of the locked input and
the VCR output will change from
orange to red.
iv
Depending on the setting of the TV2
button, the TV2 lamp will change
from orange to either red or green.
To watch the video being recorded
i
Make sure your TV is on the AV
channel and select the locked input
again, i.e., all lamps in orange.
ii
If you are watching video on the TV
connected to the “TV2” Phono
socket, skip this step and simply
release the TV2 button, i.e., TV2
lamp is either red or orange.
HOW TO MAKE TWO
DIFFERENT RECORDINGS
AT THE SAME TIME:
1. Connect the two VCR’s respectively
to SCART “1” and SCART “2”.
2. Connect the equipment providing
the video source to either SCART
“3”, SCART “4” or SCART “5”.
3. Select the input your require,
SCART “3”, “4” or “5” and
depress the “LOCK” key once.
Then select one of the remaining
inputs, SCART “3”, “4” or “5”.
4. Make sure the “TV2” button is
depressed, i.e., TV2 lamp in green.
5. Select the AV channel on each
VCR and depress the RECORD key
on each.
6. Depress the PLAY keys on the
equipment providing the video
source.
Two different recordings will start.
IMPORTANT: - You should
not perform any other
switching on the
“QUINTRO+” until
recording has finished.