BabyLove BL620A 2010 Instruction Book

Manual is about: INFANT CARRIER

Summary of BL620A 2010

  • Page 1

    Information for buyers: for babies up to approximately 6 months this infant restraint must be installed so that the baby is rearward facing at all times. Instruction book infant carrier series no. Bl620a/2010 important: keep this booklet in the place provided on the child restraint.

  • Page 2

    2 3 index introduction introduction warnings shoulder height markers & a growing child the next step features: carrier parts features: base parts suitable for use how to set-up how to install how to use care and maintenance travelling tips accessories travel system -use with stroller installation of...

  • Page 3

    Do not leave children unattended in the car. : 4 5 • use the restraint exactly as shown in the instructions. • fittherestraintfirmlytothecarseat. • fittheharnessfirmlytothechild. • a loose restraint or harness is dangerous. • do not leave children unattended in the car. • supervision of children is ...

  • Page 4

    Shoulder height markers & a growing child maximum shoulder height marker maximum shoulder height marker older baby new born the carrier is not suitable for your child when their shoulders are above the shoulder height marker. If the babies neck muscles are unable to support their head then the child...

  • Page 5

    Choose from: • convertible child seat, if the convertible seat is suitable for approximately 12 months then continue to keep your child rearward-facing until the shoulders reach the lowest marker. Then turn to forward facing until the child reaches the top marker - approximately 4 years of age. Or •...

  • Page 6

    Features: carrier parts 12. Instruction book storage pocket 13. Release lever for stroller and base 14. Upper anchorage strap guides 15. Metal strap connector 16. Base latch 17. Stroller latch 18. Canopy attachment points 19. Attachment clip 20. Upper anchorage strap adjuster 21. Upper anchorage str...

  • Page 7

    12 features: base parts 27. Seat belt clip 28. Carrier latching points 29. Rearward-facing belt path label (shown in blue) 30. Vehicle seat belt path 31. Seat belt routing tabs suitable for use 28 28 29 30 31 27 13 660mm 440mm seat width 430mm to be used with a lap-sash or lap only seat belt in the ...

  • Page 8

    14 how to set-up 15 suitable for use the upper anchorage strap must always be fitted when the child restraint is used in a vehicle. Do not use the restraint without the upper anchorage strap correctly attached. The upper anchorage strap must be attached to an anchorage point using an extension strap...

  • Page 9

    16 how to set-up how to set-up 17 a. The carrier features a sturdy carry handle. At the side of the handle there is a handle release buttons on each side which control the three positions of the handle. The “carry” position is upright and suitable to carry the baby. Ensure the handle is locked, and ...

  • Page 10

    18 how to set-up how to set-up 19 d. Place baby into carrier lying on its back so that the buckle is between the baby’s legs. Correctfitmentoftheharnessisveryimportantasitrestrainsthebabyinthe carrier.Theharnessmustfitfirmlyarounduppertorsoofthebabyandbe positioned so as to leave the baby’s arms and...

  • Page 11

    20 how to set-up how to set-up 21 f. At the rear of the carrier, remove one of the harness shoulder straps from metal strap connector by slipping strap through open slot. The metal strap connector is shown in diagram right. G. Pull the shoulder strap through slot. H. Insert the shoulder strap throug...

  • Page 12

    22 23 how to install how to install consultthecarowner’shandbookforlocationofanchorfittingsoranchorage points.Somevehiclemanufacturersrecentlyhaveananchorfittingfittedinthecar. Ifthereisnochildrestraintanchorfittingorchildrestraintanchorpointrefertopage 48fortheinstallationoftheanchorfittingaswellas...

  • Page 13

    24 25 press down firmlyonbase pull seatbelt tight lap belt tab seat belt clip c.Forcar’swithflatseats,some packing(suchasfirmlyrolledup nappyortowel)mayberequired to get a better angle and to have the stabilising bar contact the car’s seat back or close to the seat back. D. Place the base into the c...

  • Page 14

    26 how to use how to use 27 installing upper anchorage strap a.Locatethechildrestraintanchorfitting in the car that is directly behind the seat location in the rear seat you have chosen. Refer to the car owner’s manual for the location (if there is no anchoragefittingthenrefertopage48for instruction...

  • Page 15

    28 29 how to use how to use placing baby in carrier when positioning baby into carrier make sure baby’s back is fully supported ontotheflatsectionandthebaby’snappyarea(bottom)isrestinginthebottom curvature as shown. It is recommended that bulky nappies are not used when baby is travelling in the car...

  • Page 16

    30 31 how to use how to use d. Place each arm through each shoulder strap of the harness. Position the buckle of the crotch strap as shown right. E. Fit either harness tongue into the harness buckle followed by the other tongue until a click is heard. If the second tongue does not engage - press the...

  • Page 17

    32 33 how to use how to use placing baby & carrier in base a. Position the carrier over the top of the base. Make sure the harness adjustment strap is not caught between carrier and base then lower the carrier into position. Click b. Push down on the carrier until an audible click is heard. Pull on ...

  • Page 18

    34 35 how to use how to use removing baby & carrier from base a. Loosen the upper anchorage strap by fully pressing the adjuster button while pulling the upper anchorage strap. Ensure that the adjuster does not fall on the baby. B. Remove the upper anchorage strap from the locating slots in the carr...

  • Page 19

    Care and maintenance care and maintenance regular care of this restraint: please check the following items regularly to ensure the safety of your child: a. Check the webbing for fraying. B.Ensuretheinsideofthebuckleisfreeofforeignmatter,foodorfeedingliquids. Check that the buckle clicks and is not s...

  • Page 20

    Care and maintenance care and maintenance to replace the cover a. Place the cover over the carrier. B. Feed the shoulder harness straps through lap strap slots in cover. Ensure that there are no twists in all straps at the back of the carrier. C. Feed the crotch buckle as well as the harness adjuste...

  • Page 21

    Care and maintenance to clean harness buckle: ifstickyliquidssuchasbabyformula,fruitjuice,etc.Getinsideyourharness buckle, it may become sluggish. An indication of a sluggish harness buckle is that you cannot hear a click when engaging the harness tongues. To restore the harness buckle to good worki...

  • Page 22

    Travelling tips clothing/bathing take several changes of clothing and bibs for possible car sickness. Disposable nappies and liners are very handy while travelling. Since it is often warmer in the car, dress the baby in light clothing. When cooler, it is easier to place a blanket over the baby than ...

  • Page 23

    44 45 travel system-use with stroller this carrier is designed to be connected to compatible babylove strollers. The following pages provide a general instructions about using the carrier with a stroller which may differ slightly for some strollers. Preferably use the attachment instructions provide...

  • Page 24

    A. Engage the brakes. B. Press both buttons on the side of the handle. Then continue to rotate the handle slightly forwards and then release. Rotate the handle up over the canopy. Check the handle is locked in the upright position. C. To release the carrier from the stroller, locate the release leve...

  • Page 25

    48 49 distance to measure to the anchor point adjustable upper anchorage strap. The shaded areas of this diagram illustrate the possible locations of the anchor fitting.Withineachshadedareaisananchorfittingshowingthecorrectwayto installthefitting.Ensuretheanchorfittingisalignedasillustratedunlesssta...

  • Page 26

    50 51 front of vehicle if the car is not fitted with child restraint anchorage points for sedans only - drill 9mm diameter hole in the parcel shelf on the centre line of the seating position as shown in fig.3. Before drilling the hole, check the underside for accessibility. Install the anchor bolt a...

  • Page 27

    52 53 installation accessories car installation accessories (available from retailers of babylove products) extra anchor kits: are available if using the restraint in additional vehicles. Re-order number: k402 extension straps: mayberequiredforvehicleswithoutafixedparcelshelf. Re-order number: k304 ...

  • Page 28

    54 55 notes notes.

  • Page 29: P/no. 2200878/a

    We reserve the right to alter this product without notice in our constant endeavour for improvement. © 2007 - 2011 nursery elegance pty. Ltd. Trademarks of babylove and devices are owned by nursery elegance pty. Ltd. This product is covered by australian patent application. P/no. 2200878/a.