BabyLove BL620A 2010 Instruction Book - page 12
22
23
HOW TO INSTALL
HOW TO INSTALL
Consultthecarowner’shandbookforlocationofanchorfittingsoranchorage
points.Somevehiclemanufacturersrecentlyhaveananchorfittingfittedinthecar.
Ifthereisnochildrestraintanchorfittingorchildrestraintanchorpointrefertopage
48fortheinstallationoftheanchorfittingaswellastheuseofextensionstraps.
Ananchorfittingisrequiredtoattachtheupperanchoragestraptofullyinstallthe
Carrier to the car. The upper anchorage strap must be used with this carrier when
used in the car.
For installing the Base to the car, select a seating position with a child restraint
anchorfittingdirectlybehindtheseatingposition.
Level Indicator Line on
both sides of base
INSTALLING THE BASE TO THE CAR
Pullflapoutward
Then, adjust recline foot
A. Place the base and Carrier on vehicle seat
in a seating position where a child restraint
anchorfittingisinstalled.TheLevel
Indicator Line needs to be level with the
road, (i.e. parallel with the road surface).
Check and adjust the recline angle of the
base if necessary as follows.
B. If your car’s seat is contoured then you
may need to adjust the angle of the base
so your baby is not too upright.
The recline angle may be altered using
the four position adjustment foot located
at the stabilising bar end of the base.
To adjust, pull out on angle adjustment
foot adjuster and lower or raise the angle
adjustment foot to the desired position.
Place back in the seating position and
recheck the Level Indicator Line.
Maximum
compensation
Minimum
compensation
Road
Road