BabyLove BL620A 2010 Instruction Book - page 23
44
45
TRAVEL SYSTEM-USE WITH STROLLER
This Carrier is designed to be connected to compatible Babylove strollers. The
following pages provide a general instructions about using the Carrier with a
stroller which may differ slightly for some strollers. Preferably use the attachment
instructions provided with your stroller. Use the stroller in accordance with the
instructions supplied with the stroller.
DO NOT LEAVE THE CHILD IN THE CARRIER FOR EXTENDED PERIODS.
THE CARRIER IS DESIGNED TO PROVIDE MOBILITY OUTSIDE OF THE CAR BUT IT
SHOULD NOT BE USED IN PLACE OF AN APPROPRIATE COT. DO NOT LEAVE THE
BAY IN THE CARRIER FOR EXTENDED PERIODS.
THE CARRIER MUST ONLY BE USED WITH A BABYLOVE STROLLER WITH
COMPATIBLE ATTACHMENTS. DO NOT USE WITH ANY OTHER STROLLER.
IF IN DOUBT ABOUT THE METHOD OF INSTALLATION OR SUITABLE COMPATIBLE
STROLLERS, CONTACT NURSERY ELEGANCE CUSTOMER SERVICE ON
1300 131 477.
Always ensure the baby is secured in the Carrier with the harness at all times.
TRAVEL SYSTEM-USE WITH STROLLER
NOTE - Ensure that the child is harnessed in the
Carrier according to these instructions. See
pages 28 to 31.
A. Engage the brakes and place the stroller
backrest into the fully reclined position.
B. Locate and uncover the mounting slots on the
stroller armrest.
C. Hold the Carrier by the carry handle, and also
if you prefer, by the front rebound bar. Face
the feet end of the Carrier towards the stroller
backrest.
D. Lower the Carrier into the exposed mounting
slots.Pressdownfirmlyonbothsidesuntilyou
hear it click and it locks into place.
IMPORTANT:
Ensure that the Carrier is locked into place by
pulling up on both sides. Do not use the Carrier
if it is not correctly installed.
E. Rotate the Carrier handle down if you prefer.
Press both buttons and hold them in. Then rotate
the handle slightly backwards and then release.
Continue to rotate the handle back over the
canopy. Push down until it locks.
Use the harness at all times.
FITTING THE CARRIER TO THE STROLLER