Babymoov A014201 Instruction Manual - page 12
12
c. Short touch icons 19 or 20 , set the lower temperature limit below which the unit
will provide an alarm. The allowed selectable temperature range is -9
to +44
℃
℃
or 2
lower than the selected upper limit. In case is selected, no lower
℃
temperature limit is set. Confirm your setting by short press of button 18 and
exit from menu.
d. Please note the setting of upper and lower temperature limits are same for both
BU.
e. Under standby mode, short touch of menu icon 21 will show the setting of out
of range alarm function and temperature alarm.
3. Place this unit at a reasonable distance away from the baby unit to avoid feedback.
Too close a distance will create a screeching sound at the speaker 24.
4. Once it receives a signal from the BU, the visual level meter 25 will light up. The
number of segments being lighted up vary along with the sound. This feature is
useful in case the parents prefer to turn down the speaker volume to keep the
environment quiet. Depending the signal is coming from which BU, the
corresponding baby unit no. icon
1
33 or
2
34 will be lighted up.
5. Short press the power ON/OFF button 18 to light up the touch key icons
( ). Short touch the up/down icons 19 or 20 to adjust the volume of
speaker 24, the segments of visual level meter 25 as well as the temperature
indicator 26 will change during adjustment. The more segments lighted up and
higher the number, the bigger is the loudness. There are total 5 levels of loudness.
When the minimum level is reached, further touch of the down icon 19 will totally
mute the speaker 24 volume and the speaker mute icon will show up.
6. This unit is equipped with a vibration alert. Short touch the vibration icon 22 and
the icon 29 will show up. Once the received baby’s voice is loud enough, the
vibrator starts to function. This feature is useful when the parent is working under
noisy environment (e.g. vacuum cleaning). To save battery power, it is
recommended not to use the vibration alert frequently. To switch off vibration, short
touch the vibration icon 22 again and the icon 29 goes off.
PU is receiving
signal from BU no. 1
PU is receiving
signal from BU no. 2
BC-63_Manual_05.pdf 12 22/7/14 6:10 pm