Babymoov A014201 Instruction Manual - page 5
2.
Charging up the Lithium rechargeable battery
Connect the output plug of supplied 5V AC adapter to USB port 37 of the
charger stand, make sure the polarity is correct. The unit can either be in
switch ON or OFF condition, place it into the charger stand. The charging
indicator 36 should light up white. Adjust the position of parent unit in
case the indicator 36 does not light up. During charging, the power on /
battery low icon
27 should be flashing red. Once the battery is fully
charged up, the power on / battery low icon
27 should stay steady
green. Either you can take it out or keep placing it in the charger stand will
cause no damage to battery. In the latter case, when the battery is being
consumed and voltage falls to a certain level, the charger stand will
automatically start charging up the battery again.
Note : Before using the parent unit for the first time, charge up the Li polymer
battery for at least three hours. It is recommended to switch off the unit during first
charging.
Even without the Li battery pack being installed, the unit can still oprate normally
once place in changer stand, while the power on icon
27 will always stay steady
green.
CAUTION : BESURE THE BATTERY IN PARENT UNIT IS RECHARGEABLE
TYPE BEFORE PLACING IN CHARGER STAND. OTHERWISE EXPLSION MY
RESULT .
5
!
37
BC-63_Manual_05.pdf 5 22/7/14 6:10 pm