Babyviewer RA-4500 User Manual - User Manual
user manual
10
• Place the Li-ion battery pack in the battery compartment. Ensure that the battery contacts do make
contact with the charge contacts as illustrated.
• Carefully close the battery compartment and rotate the belt clip back downwards.
Connecting the parent unit to the AC mains
• Insert the small plug of the AC mains adapter in the mains power connector
28
and plug the AC
mains
adapter into a mains connector (100~240 V - 50/60 Hz).
It takes around 10 hours to fully charge the batteries.
INSTALLING THE BABYVIEWER RA-4500
Fine tuning
• Place the camera in a convenient location, point the lens of the camera to the observation area.
• Adjust the angle by rotation the camera.
CAUTION!
Do not place the camera and wires within the baby’s reach!
Fix the camera at least 1 meter away from the baby.
OPERATION AND USE
Switching the baby unit and parent unit on and off
• Press the on/off button
25
to switch on the parent unit. The display
20
is activated.
• Slide the on/off switch
4
up to switch on the baby unit. The on/off LED
1
is activated.
The parent unit will try to establish a connection with the baby unit. If captured image
from the camera is displayed, a connection has been established.
• Press the on/off button
25
to switch off the parent unit
(press and hold until the display goes blank).
• Slide the on/off switch
4
down to switch off the baby unit.
RA-4500_usermanual Jan 2014.indd 10
21/01/2014 11:53 am