Babyviewer RA-4500 User Manual - User Manual
user manual
17
Babyviewer RA-4500
Problem causes and solutions
The following table is intended to help you localise and solveminor problems.
PROBLEM
POSSIBLE CAUSE
SOLUTION
The rechargeable battery
pack of the parent unit
does not charge
Charging station plug not connected
Dirty Contacts
The rechargeable battery pack is defective
Connect plug
Clean the battery terminals and
charging station contacts with a soft
cloth
Replace the battery pack
Parent unit does not
switch on (display
remains black)
The rechargeable battery pack is not
charged
Equipment defective
Charge the battery pack
Contact customer service
The ‘orange’ icon
appears on the parent
unit display t of r
Baby unit not switched on
Switch on the baby unit
The parent unit and baby unit are too far
apart
The parent unit is not registered with the
baby unit
The wrong camera is selected.
Reduce the distance between the
parent unit and the baby unit
Register the parent unit with the baby
unit (see “10.15 Registering the parent
unit with the baby unit or register a
new camera.”
See “10.16 Selecting the camera”
The parent unit does not
reproduce the sounds
picked up by the baby
unit
The volume setting of the parent unit may
be too low.
The microphone sensitivity of the baby unit
may be set too low.
Increase the volume setting of the
parent unit
Check the VOX sensitivity and the
volume setting of the parent unit and
increase if necessary.
Limited range and
interference during
transmission
The range of the equipment depends on
the surroundings. Steel structures and
concrete walls can impair transmission.
Avoid obstacles as much as possible.
The equipment emits a
high pitched whistle
The parent unit and baby unit are too close
together
Increase the distance to at least 2
metres
RA-4500_usermanual Jan 2014.indd 17
21/01/2014 11:53 am