Bacsa ACS-Z User Manual - page 5
VERSIÓN 12.11.06
Press【Set】 to exit from the setting state when in the process of setting. The set
value is invalid.
3.2. Counting mode
Press【 Set】 to sample weight in the counting model. It displays “SAP X” (X is the
sample number).
1. Press
【 ↑
】 to
Press
【E nter】 to m ake sure.
2. The weight window displays “LOAD-C” after the sample number is chosen. Put
enough number of samples then press
【E nter】 to
finish sample.
3. There are two instance of unit weight lacking:
a. When the weight window displays “-SLAC-”, it means the unit weight of
sample is less than 80% of division. You still can count but the counting
may be inaccurate. The signal will disappear after about 3 seconds.
b. When the weight window displays “-CSL-”, it means the unit weight of
sample is not enough at all. Please press
【Set】 to re
-sample.
Press
【E nter】 to exit back to the counti
Press
【Set】 to exit from the sample
ple.
3.3. Percentum mode
1. Press【 Set】 in the percentum state to display “LOAD-P”. There are two ways
to sample:
1.1. Put enough samples on the platform then press【 Enter】 to finish sample.
1.2. Press【 Unit】 then the scale displays “000000”. Press【 ↑
】 and【Enter】 to
input the weight value.
2. When the sample weighed less than 0.1% FS., the weight window displays “-
CSL-”. It means the sample is not enough. You should re-sample.
Press【Set】 to re-sample. Press【E nter】 to exit back to the weighing model.
Press【Set】 to exit from the sample state in the process of sample.
Balanza ASC
5