Baer UniMod Ethernet Operation Manual - page 8
UniMod Ethernet
8
Programming with the software UniModSet/MetcomTSet
After program start, select the register tab
“Ethernet”. Then choose one of the standard configura-
tions
(„
Assign“, for E-Meters, Metcom MWT32, M-Bus-Systems or DLMS) or assign the following
parameters manually:
Baud rate, e.g.: 9600 Baud
Data format, e.g.: 7E1
Control, e.g.: ignore DTR, no handshake
Responses, e.g.: as text or numbers
Function: Box to Box Client or leased line between two modems
IP-Address (and port number)
Gateway
Subnet-Mask
Data transmit control
Keep alive
For the network parameters ask your system administrator. Then select in the
menu „Settings -
Interface“ the serial port (e.g. COM1) and send („
Write“) the chosen device configuration to the
UniMod Ethernet. Additionally you can receive („Read“) the configuration from a connected UniMod
Ethernet.
In the
menu „File“ the current configuration can be saved („File save as...“).
An existing configuration can be loaded by means of
„File load“.
Further it is possible to set the Ethernet (LAN) parameter.
Experienced users can alter the device configuration with the internal terminal program using AT
commands.