Balboa bba 2 Installation Manual - page 18
42296-D, bba2 Manual
© 2017 Balboa Water Group. Single Source Solution. All rights reserved.
1382 Bell Avenue | Tustin, CA 92780 | p 714.384.0384 | www.balboawater.com
We reserve the right to change technical data without further notice.
18
Page
Topside Panel Interface
(Topside panels: TP600, TP400)
Topside Panel Options
Topside Panel: TP400
(software version 2.12 or above)
Topside Panel: TP600
(software version 2.12 or above)
The system pack and all electronic components connected to the
system pack are referred to as “
system” in this manual.
The power supply connects to the system pack at the circuit
board connector labeled “A / V.” Refer to the system pack wire
diagram for circuit board connector positions. The wire diagram is
inside the system pack.
Power Supply
UL1563, 12V
bba2
Amplifier
System Pack
(software version 37.0 or later)
Spa Equipment
Determine Panel Software Version
(Topside panels: TP600, TP400)
RANGE
READY
font sample
RANGE
READY
font sample
1 - Start at the home screen. The
water temperature is displayed by
default.
2 - Press Temp (or Warm or
Cool. This applies to all steps
where Temp is pressed.) to begin
navigation. The set temperature
(not the water temperature) will
begin flashing in the LCD display.
3 - Press Light until this screen
appears. “UTIL” is an abbreviation
for “Utilities.”
4 - Press Temp once to make
this screen appear. “INFO” is an
abbreviation for “Information.”
6 - Press Light until this
screen appears. “PANL” is an
abbreviation for “Panel.”
5 - Press Temp once again to
make this screen appear. “SSID”
stands for “System software
identification.”
7 - Press Temp to view the panel
software version.