Balt ROLZ-2 Assembly Instructions Manual - page 5
5
Place the Back Panel (P-3) with the Holes facing
up and install 6 each Cam Locks (K) into the
large holes (Pre-installed) as shown
in illustration # 2.
Illustration # 2
Place the Top Platform (P-7)and
the Fixed Shelf (P-5) with the Pre-
drilled Holes facing up and install
4 Cam Locks (K) into the 4 large
holes in each as shown
in illustration # 3.
Place the Bottom Platform (P-9)
with the Pre-drilled Holes facing
up and install 4 each Cam Locks
(K) into the 4 large holes.
Install 2 each Glides (R) as shown
in illustration # 4.
7.
Be sure that arrow on
top of Camlock (N)
aligns with centerline of
Edge Drilled hole.
Phillips
Screwdriver
Centerline of
Edge Drilled
hole.
Arrow
K
P-3
P-9
R
K
Illustration # 4
Illustration # 3
P-7/P-5
K
8.
9.
6.
NOTE: Hole is
closer to bottom of
Back Panel((P-3).