Balt ROLZ-2 Assembly Instructions Manual - page 7
7
Illustration # 6
11.
Illustration # 7A
A3
A3
P-4
Attach Handle (P-8) to the Side Panels
(P-1 & P-2) using 2 each Screws (A) as
shown in illustration # 6. Tighten Screws
(A) using Small Allen Wrench (N1).
SECURE THE CAM LOCKS located at
the top of the Back Panel and in the top shelf
by turning Cam Locks (L) 1/4” Turn until they
lock.
D
P-8
P12
A1
A
A
S
A1
P
D
12.
13A.
P-1
P-2
Install 2 Wheels (D) on either side of the unit using 2
each Long Screw (A1), 6 each Washers (P), 2 each
Washers (S) and secure using 1 Threaded Axle (P-12)
and Big Allen Wrench (N) as shown in illustration # 6.
Squeeze Plastic Clip as shown by arrows in illustration
# 7A to release inner keyboard slide
(Squeeze up on the left side/down on the right side).
Illustration # 7B
Attach Keyboard Shelf (P-4) to the
Keyboard Slides (B) using 4 each
screws (A 3) as shown in
illustration # 7B.
[Slide Keyboard Shelf Assembly
back into the Keyboard Slides.]
B
A3
13B.
Insert Screw
in this hole.
Insert Screw
in this hole.
FRONT of Slide
BACK of Slide
B
Plastic Clip
P