Bandit 240 PB Installation And User Manual - page 5
Bandit 240 PB Installation and User Guide
5
Mounting procedure—wall
1. Select a mounting location. Be sure the location you select complies with the
requirements listed in the section “Site selection” on page 3.
2. If you ordered the optional Handy-Boy jig, place Bandit 240 PB on the jig.
3. Connect power wires to Bandit.
4. Mark and drill holes to ½" depth.
5. Attach the mounting plate using screws.
6. Position and secure Bandit on the mounting plate.
Proceed to “Electrical Connection” on page 6.
Mounting procedure—floor
1. Select a mounting location. Be sure the location you select complies with the
requirements listed in the section “Site selection” on page 3.
2. If you ordered the optional Handy-Boy jig, place Bandit 240 PB on the jig.
3. Connect power wires to Bandit.
4. On the floor, mark and drill holes to ½" depth.
5. Attach the mounting plate using screws.
6. Position and secure Bandit on the mounting plate.
Proceed to “Electrical Connection” on page 6.
Mounting procedure—concealed location
1. Select a mounting location. Be sure the location you select complies with the
requirements listed in the section “Site selection” on page 3. In particular, ensure you
have enough ventilation to allow heat dissipation.
2. If you ordered the optional Handy-Boy jig, place Bandit 240 PB on the jig.
3. Connect power wires to Bandit.
4. On the floor or wall, mark the location of Bandit.
5. On the door concealing Bandit, mark and drill a hole with 2" diameter.
6. On the mounting surface, mark and drill holes to ½" depth.