Bandit 240 PB Installation And User Manual - Electrical Connection
Other manuals for 240 PB:
Installation Manual
of
10
Bandit 240 PB Installation and User Guide
6
7. Attach the mounting plate using screws
8. Position and secure Bandit on the mounting plate.
9. If you ordered the optional extended ejection nozzle, attach it to Bandit through the 2"
hole.
Proceed to “Electrical Connection.”
Electrical Connection
Caution—Installation of Bandit 240 PB requires a 110 VAC power source
and a dedicated ground. Be sure you follow all local safety requirements
and building codes when installing Bandit.
Refer to Figure 1 when making electrical connections.
Figure 1 - Bandit 240 PB PCB
1. Remove the real jumper to disarm fog ejection.
2. Remove power from electrical line to be connected to Bandit 240 PB.