Banjo 301PBIW Instruction Manual - Disassembly Instructions:
Disassembly Instructions:
1. Drain all fluids from the pump. Remove the
drain plug (18003) from the lower front of the
pump housing to drain the pump. Remove fill
plug (18205) from top of reservoir. Remove
drain plug (17032) from lower side of reservoir.
2. Using a 9/16" socket or wrench, remove the
impeller clamp assembly (18129) from the
pump.
3. Remove drive unit from the pump. This is done
by using a 9/16" wrench to remove the four
3/8" bolts (17704) that hold the drive unit to the
wet seal reservoir adapter (18203A). Once the
bolts are removed, separate the drive unit from
the pump.
4. Remove wet seal assembly from pump
housing. This is done by removing the six 3/8"
nuts (V20019) and 3/8" lock washers (V20018)
from the wet seal reservoir adapter (18203A).
The wet seal assembly can then be pried away
from the pump housing and removed. Remove
the handle (18033) from the wet seal adapter.
1