Banjo 301PBIW Instruction Manual - Assembly Instructions:
of
8
Assembly Instructions:
5. Install gaskets to front and back of cover plate
and install cover plate on the pump housing.
6. Install seal spring assembly on the impeller
shaft. Lubricate the shaft and viton portion of
the seal with petroleum jelly. Slide onto shaft
using your thumbs.
7. Mate the reservoir adapter (18203A) with the
cover plate (18202A). This is done by sliding
the reservoir over the shaft and onto the cover
plate. Align the bolt patterns of the two parts,
also align the components such that the fill plug
hole of the reservoir is facing up.
8. Install six 3/8 lock washers (V20018) and 3/8"
nuts (V20019) onto the six wet seal housing
studs and tighten.
4