Banjo 301PBIW Instruction Manual - Assembly Instructions:
Assembly Instructions:
9. Mate the wet seal and pump assembly to the
drive unit. Insert the shaft of the drive unit into
the wet seal shaft. Install four 3/8" bolts (17704)
with lock washers (V20018) through the wet
seal adapter and into the drive unit.
10. Install the impeller shaft clamp (18129) over
the serrated tines of the wet seal shaft.
Lubricate the clamp bolts with anti-seize thread
lubricant and tighten to 40 ft.lb. minimum. It
may be necessary to further tighten the clamp
depending upon drive unit size and pump load
during operation.
11. Fill the reservoir
¾
full with a 50% water &
50% ethylene glycol (anti-freeze) mix. The fluid
level should cover the top of the seal
assembly. Install the
¾
" fill plug (18205) using
a thread sealant.
12. Remove the shim from the pump.
5