Banner Q3X Instruction Manual - 3 Sensor Programming
3 Sensor Programming
Program the sensor using the buttons on the sensor or the input wire (limited programming options; see
Remote Input
on
page 13 for details).
In addition to programming the sensor, use the input wire to disable the buttons for security, preventing unauthorized or
accidental programming changes. See
Locking and Unlocking the Sensor Buttons
on page 15 for more information.
3.1 Setup Mode
1. Access Setup mode from Run mode by pressing and holding MODE for longer than 2 seconds.
2. Use
or
to navigate through the top menu.
3. Select the desired submenu by pressing
and
simultaneously.
4. Press
or
to view the available options in the submenu.
5. Select a submenu option.
•
Press
and
simultaneously to select and save a submenu option and return to the top menu.
•
Press
and
simultaneously for longer than 2 seconds to select and save a submenu option and
return to Run mode.
NOTE: The current submenu selection is solid, all other selections flash.
To exit Setup mode from the top menu and return to Run mode, navigate to
and press
and
simultaneously, or press and hold
and
simultaneously for longer than 2 seconds to return to Run mode from
anywhere in the top menu.
3.1.1 Output Operation
Use this menu to select the output operation mode. The default is light operate.
•
—Light operate. The output is on when the sensor detects a light state
•
—Dark operate. The output is on when the sensor detects a dark state
3.1.2 TEACH Menu
Use this menu to select the TEACH mode. The default is two-point static TEACH mode.
•
—Two-point static TEACH
•
—Dynamic TEACH
•
—Window set
•
—Light set
•
—Dark set
After the TEACH mode is selected, from Run mode, press and hold TEACH for longer than 2 seconds to access the TEACH
mode and teach the sensor. See
TEACH Procedures
on page 15 for additional information and remote input TEACH
instructions.
When Window set, Light set, or Dark set are selected, the sensor returns to the Setup menu and the Offset Percentage
menu (
) becomes available to set the offset percentage.
3.1.3 Offset Percentage
Use this menu to select the offset percentage when Window set, Light set, or Dark set TEACH modes are selected. The
default is 20% for Window and Light Set, and 50% for Dark Set.
Window and Light Set options:
Q3X Laser Contrast Sensor
www.bannerengineering.com - Tel: 763.544.3164
9