Barazza 1PLB0361TX-00 series Installation And Use Manual - 5”
24
UTILISATION DES BRÛLEURS
Avant l’utilisation, contrôler que les cha-
peaux (2), les brûleurs (3) et les grilles (1) soient
placés correctement.
Les brûleurs sont équipés de thermocouple
de sécurité (8). Le thermocouple est un dispo-
sitif sensible à la chaleur : tant qu’il est chauffé
par la flamme du brûleur allumé, il permet la sortie de
gaz du gicleur (9) ; si la flamme devait s’éteindre pour
quelque raison que ce soit (ex: débordement accidentel
de liquide de la casserole), le thermocouple se refroidit
en quelques secondes et bloque toute sortie de gaz du
gicleur en empêchant que la pièce ne puisse être satu-
rée de gaz imbrûlé.
Allumage des brûleurs
1)
(fig. 14)
Enfoncer à fond la manette du brûleur à
allumer en tournant en même temps la manette
jusqu’au symbole
-> la bougie (7) produira une
étincelle pour allumer le brûleur sélectionné.
2) Une fois l’allumage effectué, maintenir encore enfon-
cée à fond la manette pendant environ 5 secondes
ceci en la maintenant toujours sur le symbole
, puis la relâcher : ce temps permet de chauffer le
thermocouple de sécurité. Si le brûleur s’éteint en
relâchant de la manette, cela signifie que le ther-
mocouple n’a pas été suffisamment chauffé : répéter
les opérations 1) et 2) en maintenant davantage la
manette enfoncée après l’allumage du brûleur.
24
1
3
2
7
8
9
1
2
5”
extinction
off
MAX
MIN
14
USING THE BURNERS
Before using the appliance, check that the
flame distributors (2), the burners (3) and the racks
(1) are correctly positioned.
The burners are equipped with safety thermo-
couples (8). The thermocouple is a heat-sensitive
device: it is heated by the ignited burner flame,
which permits the thermocouple to control the gas flow
from the nozzle (9); in the case where the flame should go
out for whatever reason, (for example, accidental liquid
spillage from a saucepan), the thermocouple immediately
cools down, blocking the gas flow from the nozzle, subse-
quently preventing unburned gas from filling the room.
Switching on the burners
1)
(figure 14)
Press down fully on the knob regulating
the burner you wish to switch on
whilst at the same
time rotating it until the symbol
-> appears; the
spark plug (7) will fire sparks in order to switch on the
chosen burner.
2) Once ignited, keep pressing down fully on the knob
for approximately
5 seconds, still with the symbol
showing, then release the knob: this time period allows
the safety thermocouple to heat up. If upon releasing the
knob, the burner does not remain ignited, this is an indi-
cator that the thermocouple was not sufficiently heated:
repeat stages 1) and 2) keeping the knob pressed down
for longer after the ignition of the burner.
UTILISATION DE L’APPAREIL