Baroness LM2700 Operator's Manual - page 21
−20−
Operation method of each part
3.
Caution
3-1 About the mechanical operation
Check whether the operation state of each part is good, and the brake disc, tires, steering,
and mower do not have abnormalities in particular before operating the engine. In any
cases, operate the engine by the speed that can carry out the urgency stop. Locate and
remove all debris, in the operating area before using equipment.
Warning
3-2 Before starting engine
Inspect the area where the equipment will be used.
L
Inspect whether there are no damages and the cover/guard are
L
securely fastened in place.
Never operate the engine without proper ventilation.
L
3-3 Starting and stopping the engine
Starting procedure
L
S i t o n t h e s e a t , a n d a d j u s t s e a t
1)
arrangement for safety.
Hold brake pedal down, pull parking
2)
brake lever up until it engages.
Make the reel rotary switch into the
3)
"OFF" position.
Pull the throttle lever a little to the
4)
upward.
When the ignition key is turned to the
5)
"GLOW" position, the thermostat lamp
(glow lamp) will turn on.
Glow
START
Fully turn the ignition key to rightward
6)
promptly when the thermostat lamp
(glow lamp) turns off, the starter will
o p e r a t e a n d t h e e n g i n e w i l l s t a r t .
Release it as soon as engine starts.
Ensure that the charge lamp and the
7)
engine oil pressure lamp turns off.
When they do not turn off, stop the
engine and perform the inspection and
repair.
Charge
Thermostat lamp
(Glow lamp)
Glow
Engine oil
pressure
Caution
Do not step on the shift pedal. Safety device prevents the engine
L
from starting.
Do not touch the V-Belt, the Pulley, etc. during the engine
L
rotation.
Operation of the starter is a maximum of 15 seconds. When the
L
engine still does not start, to prevent battery wastage restart
should be made 30 to 60 seconds after.
Stopping procedure
L
Hold the brake pedal down, pull the parking brake lever up until it engages.
1)
Make the reel rotary switch into the "OFF" position.
2)
Return the throttle lever to the "LOW" position.
3)
The engine will stop, when the ignition key turns to "STOP" position.
4)
3-4 About the safety device
This machine is equipped with the Safety device to starting/stopping of the engine as
interlock system.
Safety device on this machine prevents the engine from starting unless;
L
Sit on the seat.
a.
Parking brake is engaged.
b.
The reel rotation switch is "STOP" position.
c.
The shift pedal is in Neutral position. (Do not step on the shift pedal.)
d.
The interlock system will stop the engine if the operator leaves the seat without
L
engaging the parking brake.