Bartington PSU1 Operation Manual - page 14
BARTINGTON INSTRUMENT
Page 12 of 16
OM2443 ISSUE 1.0
Connecting the Equipment
Caution: Connection between the magnetometer and the power supply should not be made or
broken with the power supply switched on as this could cause damage to the magnetometer.
Connect the equipment in the following sequence:
1. Ensure the ON/OFF switch, item 10, is OFF (position “0”).
2. Connect the magnetometer to the PSU1 magnetometer socket. Ensure the connector pins are
correctly aligned with those in the socket. The locking ring should be hand-tightened only.
3. Connect BNC outputs to your external equipment, as required.
Initial Settings
Magnetometer output type selection
Before switching on the equipment, set the magnetometer output type selector switch to the correct
position for your magnetometer. Refer to the appropriate magnetometer datasheets.