Bartington PSU1 Operation Manual - page 8
BARTINGTON INSTRUMENT
Page 6 of 16
OM2443 ISSUE 1.0
PSU1 Inputs, Outputs and Controls
Back Panel Connections and Controls
1. X Signal Conditioned Output
2. Y Signal Conditioned Output
3. Z Signal Conditioned Output
The three BNC connectors carry the conditioned analogue output voltages. The conditioned
outputs are the magnetometer X, Y and Z signals after they have been modified by the low/high
pass filters and, if a balanced output magnetometer is connected, converted to single-sided
signals.
4. Space for unique serial number
5. Magnetometer Socket
This multi-pin socket is for the connection of the magnetometer cable.
Note: Ensure correct orientation of the connector (indicated by the cut-out on the connector body
aligning with the notch in the socket
2
3
4
5
1