Bulldog Scrubbers SS20 User manual - page 11
11
Machine Overview
The pump and solution solenoid, which shuts off solution fl ow when the bail handle is released, are protected from debris by the
in-line fi lter assembly. The fi lter assembly is located at the front of the machine above the brush deck. It is important to check and
clean the screened washer inside the assembly regularly to ensure proper solution fl ow. After shutting off solution fl ow, unscrew
the assembly (Note that the cone of the washer is facing away from the pump). Remove washer and rinse, reinsert and screw
assembly together, tightening by hand.
Overtightening with tools may damage the plastic threads.
A Fitting,
MGHT
B Screened
Washer
C
Hose Barb Insert
D Fitting,
FGHT
In-Line Solution Filter Assembly
Rear Squeegee
A Squeegee
B Star-shaped
knob
C Adjusting screw for angle adjustment
D Suction
hose
E Blade fastening latch
F Washers for caster height adjustment
G Caster Wheel
Axle
Cleaning the Squeegee
Check the squeegee
(A)
daily and clean
as necessary.
1. Pull off the suction hose
(D)
.
2. Loosen the two star-shaped knobs
(B)
.
3. Remove the squeegee
(A)
.
Changing the Squeegee Blades
Check the inner and outer squeegee blades
on the squeegee
(A)
weekly for signs of
wear. The squeegee blades can be reused
by turning them (can be turned for four total
uses).
1. Pull off the suction hose
(D)
, loosen the
two star-shaped knobs
(B)
and remove
the squeegee.
2. Unlock the fastening device
(E)
and re-
move the outer squeegee blade. Turn
the squeegee blade or install a new one,
as necessary. Change the inner squee-
gee blade in the same way.
Factory
Cleaning
Equipment,
Inc.
800-793-3790
www.thesweeper.com