Bulldog Scrubbers SS20 User manual - page 13
13
Machine Overview
Brush Deck Maintenance
Spray jet Maintenance
The spray jets deliver solution to the fl oor. The spray tip should be cleaned weekly to ensure good cleaning results.
To
Install
To
Remove
Figure 1
Figure 2
Figure 3
Spray tip removal and installation for cleaning
1. Remove knob located above spray jet (Figure 1).
2. Pull spray jet cover up and hold for easy access to spray tip (Figure 2).
3. Remove spray tip by hand by pushing the tip up into the nozzle body and rotate 1/4 turn clockwise (Figure 3).
4. Reinstall by pushing spray tip up into the nozzle body and rotate 1/4 turn counterclockwise until tip will not turn (Figure 3).
NOTE: Ensure that the tip is facing toward the deck.
Brush Deck Maintenance
Debris Tray Maintenance
The
Debris Tray (A)
collects debris from the fl oor during operation. It must be
cleaned regularly. Remove the tray from the deck by tilting the bottom up, then
sliding it out to the side. Empty the tray and rinse it. Return the tray by sliding
the top edge into the channel along the top-rear corner of the deck. The tray
will fall into place when fully inserted.
Brush Loading / Unloading
1. Raise brush deck. Unscrew the
knob on the right side of the deck
as shown above. Pull open the
Hinged Cover (A)
.
2. The drive side of each brush has
a black end-cap with teeth. Insert
the drive side of the brush through
the opening until engaged on to
the
Drive Hub (B)
.
3. Insert
Idle Hubs (C)
into the brush-
es while closing the hinged cover.
Tighten the knob on the cover by
hand, ensuring that the hinged idle
cover is fl ush to the deck.
Factory
Cleaning
Equipment,
Inc.
800-793-3790
www.thesweeper.com