Bullet DVR Multi- Cam V2.0 User Manual - page 6
user`s manual
user`s manual
user`s manual
Product appearance and specifications are subject to change without notice
6
Quick-Start Guide:
Your Bullet DVR has been fully tested at the factory, prior to shipping. The CF card and adapter are already inserted
inside the unit, which is pre-configured and operational right out of the box.
Step 1: Connect the 12VDC Power cable to the source battery, making sure the polarity is correct.
Step 2: Connect the Bullet Camera to one of the CAM inputs at the back of the unit.
Step 3: Plug-in the Infra-red receiver to the IR jack on the side of the unit.
Step 4: Plug-in the Power Cable to the POWER jack on the unit. Initialization will start and the DVR is ready
to record once the status light remains steady green.
Step 5: Press the REC button
on the wireless remote to start recording.
Connecting a camera to the DVR:
The quick-connect, waterproof connector fitted on the Bullet Camera can only mate with the CAM plug on
the DVR if they are aligned correctly. Once aligned, push them together fully and then twist the connector 90
degrees to the right, in order to lock the barrels. To release, simply grab the barrels again and twist to the left,
then pull them apart.
Bullet DVR Operation
:
1. Press the REC button to start recording a new video file.
2. Pressthe Stop button to end the recording.
3. Disconnect the Power Cable before removing the CF card from the unit.
4. Insert the CF card into the computer to playback your videos.
Safety and Warning
:
o Never insert or remove the CF card from the unit while power is applied.
o There are no user serviceable parts inside, please do not open the unit. If you require service,
please contact your dealer.
o Do not remove or tamper with the Serial Number sticker located on the side of the unit.
Doing so will void your warranty.
Ejecting the CF memory card
:
1. Wait until the Status LED turns to steady green.
2. Disconnect the 12VDC Power Cable or AC Adapter.
3. Firmly press the Eject button and grab the CF card adapter by the edges and pull it out
of the unit.If you have problems reaching the card, there are 2 small holes on each side of the
adapter, which you can grab with a sharp object and pull out.
Caution:
Once recording has stopped, it takes a short time to save the buffered data to the memory card.The
Power Cable or AC Adapter should NOT be disconnected until the LED status light turns to steady
green. Ejecting the CF card too early could damage the integrity of the video file and ruin your
recording session.
REC
REC