Bullion microADSB User Manual - page 4
4
to control, manage and set the microADSB receiver. New options of
hardware reset are added. The device can be easily integrated in existing
wireless network or used as a peer-to-peer connected device.
New metal box with very good seal (IP65) with through holes
for mounting.
Replacing the switching regulators of supply with parametric
regulator in order to reduce noise at the receiver. S
upply voltage
limited 7-9V, DC.
ADS-B antenna connector (N male) is soldered directly to the
board
Ability to work in USB connection mode and firmware upgrade.
0.1 Features & Benefits of WIZFi 250:
- Single band 2.4GHz IEEE802.11b/g/n Wi-Fi module
- Integrated RF power amplifier : Antenna calibration is not required
- 1MB flash memory, 128KB SRAM, 1MB serial flash
- Low power consumption & excellent power management to extend
battery life
- The highest compatibility with the most of APs
- Compact size, suitable for mobile or hand-held devices
- Host Interface : UART , SPI
- Support powerful web configuration
- Soft AP (Enough memory retention, L2 switching)
- OTA (Over the Air F/W Upgrading)
- Wi-Fi Direct
1 Terms Of Use:
We offer to your attention some of the open-sources that have
inspired this project from my point of view. My experience has been
gained from the links listed below or similar:
http://www.sprut.de/electro nic/pic/projekte/adsb/adsb.htm
http://www.mikrocontro ller.net/articles/1090_MHz -ADS-B-Receiver
http://miniadsb.web99.de/
http://www.coaa.co.uk/planeplo tter.htm
http://www.wiznet.co.kr/Sub_Modules/en/product/Product_Detail.asp?cate1=&
cate2=&cate3=&pid=1201
2 Introduction
This handbook is based on:
Decoder adsbPIC hardware with firmware version 14
An ADS-B -receiver system can be used as virtual radar to
generate a live picture of the air traffic.
It
consists
from 5 stages:
1.Reception ADS-B antenna
2.1090 MHz receiver