Bullion microADSB User Manual - page 8
8
The WizFi250 is a small size wireless module.
The WizFi250 provides for the highest-level integration, featuring
802.11b/g and 802.11n.
It includes a 2.4 GHz WLAN CMOS power amplifier (PA) that meets the
output power requirements of most handheld systems.
Along with the integrated power amplifier, the WizFi250 also includes
integrated transmit and receive baluns, further reducing the overall
solution cost.
The small size & low profile physical design make it easier for system
design to enable high performance wireless connectivity without space
constrain.
Hardware WAPI acceleration engine, AES, TKIP, WPA and WPA2 are
supported to provide the latest security requirement on your network.
For the software and driver development, WIZnet provides extensive
technical document and reference software code for the system
integration.
-Integrated RF power amplifier
-Supports wireless data rates up to 65Mbit/s
-1MB Flash Memory, 128KB SRAM, 1MB Serial Flash
-Supports per packet Rx Antenna diversity
-Low power consumption & excellent power management performance.
-Small size suitable for low volume system integration.
-Easy for integration into mobile and handheld device with flexible
system configuration.
-2.412-2.484 GHz two SKUs for worldwide market.
-Lead Free design which supporting Green design requirement, RoHS
Compliance.
-Device Package : 28×20 mm (17×20 mm)
-Serial Interface : UART, SPI
-Powerful Web server provides
-Soft AP
-Enough memory retention
-Wi-Fi Security (WEP, WPA/WPA2PSK)
-L2 Switching
-OTA(Over The Air F/W Upgrading)
9 Configuration
The WizFi250 module is for the ADS-B transparent data transmission.
User first needs to configure the following wireless network parameters
before communication:
Network name(SSID)
Safety mode
Encryption (depends on your need to choose)
Defaulted TCP/UDP connection parameters:
Protocol type
Connection type
Destination address
Destination port