Bumper Boy Ultra II Operation And Maintenance - page 10
BB Trainer Revision 3.doc
16
Assemble the Components
Transmitter Assembly
Screw the antenna into the transmitter antenna
connection.
Receiver Installation
Mount receiver into the slotted area in the end plate.
Loosely fasten the receiver to the end plate, with the
antenna receptacle up, using the washers and nuts
furnished.
Install the male 12-position launcher connector to
female connector on the receiver. Press firmly to make
sure connector is engaged.
Secure the excess cable to the receiver with the wire
tie furnished.
Install the antenna into the antenna connection.
Standard Speaker Installation
(See Figure 5)
Remove the Velcro Strip with the adhesive backing
from the Standard Speaker by separating it from the
Velcro patch attached to the speaker.
Remove the adhesive backing from the Velcro strip
and attach the strip to the top of the receiver. Install
the tape with the long axis along the long axis of the
top of the receiver.
Note
Do not tighten the receiver against the end plate.
It should be mounted so that it will slide up and
down easily in order to reduce the effect of recoil.
BB Trainer Revision 3.doc
17
Attach the small speaker to the Velcro. Orientation of
the speaker can be changed to point toward the
working dog in the field.
Route the speaker cable behind the end plate, through
the cable access slot, to the bottom of the receiver.
Plug speaker into the 4-position plug on the receiver
labeled motion.
Advanced Speaker Installation
(Figure 10)
Install flat head of the bolt into
the receiver slot and tighten.
Route the connector and
wiring behind the end plate
and through the cable access
slot.
Plug the two-pole male
speaker connector into the
two-pole speaker connection
on the receiver. (Labeled
“sound”). Use the wiring strap
to secure excess wire. Leave
sufficient slack to permit
rotating the speaker 180
degrees.
The mounting swivel can be used to orient the speaker
towards the working dog.
Figure 10. Advanced
Speaker Installation