Bumper Boy Ultra II Operation And Maintenance - page 6
BB Trainer Revision 3.doc
8
Other transmitter features are:
Charger Receptacle
– Accepts connector from the
four-lead wall charger to recharge the included Ni-Metal
Hydride battery.
Antenna Connection
– Accepts the antenna for
communication with the receiver unit.
Antenna
–
Required for communication between the
transmitter and receiver.
Lanyard Ring
–
For attaching the transmitter to a
lanyard.
BB Trainer Revision 3.doc
9
Ultra II Launcher
The Bumper Boy launcher projects Bumper Boy Smart
Bumpers or Super Birds. (The term “bumpers” used in this
manual generally refers to both Smart Bumpers and Super
Birds). The receiver unit accepts the coded launch signal
from the transmitter and activates the servos that control
launch.
Receiver
(Figure 5)
The receiver is mounted loosely
on the end of the launcher frame
and connected to the sound
speaker and the mechanical
servos that initiate launching a
bumper.
The main features of the receiver are:
Toggle Switch
(Figure 6)
Program Position
- When the
toggle switch is in the left
position the receiver will accept
a new program and can be
synchronized with the
transmitter
On Position
-
When the toggle
switch is to the right the unit will
be ON.
Off Position
-
When the toggle
is in the center, or off position, the
Figure 6
. Toggle Switch
unit will turn off. The toggle switch
must be in the off position
in order to charge the battery.
Figure 5. Ultra II Receiver