Bumper Boy Ultra II Operation And Maintenance - page 14
BB Trainer Revision 3.doc
24
1
At the Launcher
:
You will see the servo activate. By pressing the
“LAUNCH”
key again the other servo will
activate.
Press again and the first
servo will
activate. The system will
continue to
loop through this sequence
with a longer delay after the second activation.
Load Test
This test confirms that the servos activate the trigger and
release the firing pin. No cartridges should be loaded for
the test.
At the Launcher:
Open the breech for each Launcher Tube
Cock each Firing Assembly. Pull the Cocking Handle
down until you hear the firing pin fall into the keyway
(distinct click).
Repeat the In House Test.
Observe that the firing pin moves from within the firing
assembly to the position that will initiate the .22 blank
cartridge.
Note
Opening the breech prevents the firing pin from
striking the edge of the breech. As long as the breech
is open you can run this test without damaging the
firing mechanism.
BB Trainer Revision 3.doc
25
Safety
The launcher can project bumpers at life threatening
velocities. When loaded, it can be as dangerous as a gun.
It should be treated like a weapon.
Children should not have access to the equipment or
ammunition.
At no time should you lean over the launcher during
the loading process.
Turn the power on before loading the launcher to
stabilize the electronics.
When cocking the launcher, make sure each trigger is
positively engaged (listen for the click).
Never point the launcher at anything except sky.
Never move the launcher when loaded.
Clear the breech when you have finished your training.
Unlatch firing mechanisms and remove shell.
DO NOT turn off electronics before unlatching and
removing shell.
CAUTION
DO NOT setup in tinder dry grass. It is possible that the .22 cal.
hot gases could start a grass fire. In any dry area caution should
be used by placing a fire protection blanket or rubber mat under
the launcher.