1. DL manuals
  2. Bunn
  3. Coffee Maker
  4. Single TF DBC
  5. Installation & Operating Manual

Bunn Single TF DBC Installation & Operating Manual

Manual is about: W/SMART FUNNEL

Summary of Single TF DBC

  • Page 1

    Dual ® tf dbc ® with smart funnel ® s/n dual068000 & up installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the manual or to obtain the illustrated parts cata...

  • Page 2

    Page 2 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) airpots, thermal carafes, decanters, gpr servers, iced tea/coffee dispensers, mcp/mca pod brewers thermal servers and thermofresh servers (mechanical and digital)- 1 year ...

  • Page 3: Main On/off

    Page 3 00656.0001 00831.0000 00658.0000 user notices the notices on this brewer should be kept in good condition. Replace unreadable or damaged labels. 37881.0000 03408.0004 03409.0004 27508.0000 as directed in the international plumbing code of the international code council and the food code manua...

  • Page 4

    Page 4 electrical requirements (models with power cord) warning - the brewer must be disconnected from the power source until specified in initial set-up. Refer to data plate on the brewer, and local/national electrical codes to determine circuit requirements. To reduce the risk of electric shock, d...

  • Page 5

    Page 5 120/208 and 120/240 volt ac single phase, 60 hz models note: this electrical service consists of 3 current carrying conductors (neutral, l1 and l2) and a separate conductor for earth ground. L2 n l1 g l2 red white green green neutral l1 black l2 red white neutral l1 black 200 and 230 volt ac ...

  • Page 6

    Page 6 plumbing requirements this brewer must be connected to a cold water system with operating pressure between 20 and 90 psi (138 and 620 kpa) from a 1 ⁄ 2 " or larger supply line. A shut-off valve should be installed in the line before the brewer. Install a regulator in the line when pressure is...

  • Page 7

    Page 7 b b c c d d e f g operating controls operating controls (a) main on/off switch this switch, located under the brewer behind the front leg, turns power on and off to all components in the brewer. (b) batch selector switches pressing the switch corresponding to the small, medium, or large batch...

  • Page 8

    Page 8 initial setup caution – the brewer must be disconnected from the power source throughout the initial setup, except when specified in the instructions. 1. Insert an empty funnel into the funnel rails of one of the brew stations. 2. Place an empty server under the funnel. 3. Connect the brewer ...

  • Page 9

    Page 9 set ready - range: 185˚f (85˚c) to 203˚f (95˚c) this function allows the operator to set the minimum temperature allowable to start a brew cycle. The range can be from 185˚f (85˚c) to within 2˚f (-1.7°c) of the set temp. The water must be at the set ready tempera- ture or higher for the displ...

  • Page 10

    Page 10 cleaning 1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on bunn-o-matic equipment. Do not clean this equipment with a water jet device. 2. Check and clean each sprayhead. The sprayhead holes must always remain open. Note:...