C-MORE EA1-TCL-M Hardware User Manual - A–20
GE SNPX Protocol – PLC Error Code Tables (cont’d)
PLC Errors for GE SNPX Protocol (Minor-Major) (cont’d)
Panel Error Code
P499 Hex Value
Description
0xE005
Service in process cannot login.
0xE105
No I/O configuration to read or delete.
0xE205
IOS could not delete configuration, or bad type.
0xE305
CPU revision number does not match.
0xE405
Memory Type for this selector does not exist.
0xE505
DOS file area not formatted.
0xE605
CPU model number does not match.
0xE705
Configuration is not valid.
0xE805
No user memory is available to allocate.
0xE905
Memory Type selector not valid in context.
0xEA05
Not logged in to process service request.
0xEB05
Task unable to be deleted.
0xEC05
Task unable to be created.
0xED05
VME bus error encountered.
0xEE05
Could not return block sizes.
0xEF05
Programmer is already attached.
0xF005
Request only valid in stop mode.
0xF105
Request only valid from programmer.
0xF205
Invalid program cannot log in.
0xF305
I/O configuration mismatch.
0xF405
Invalid input parameter in request.
0xF505
Invalid password.
0xF605
Invalid sweep state to set.
0xF705
Required to log in to a task for service.
0xF805
Invalid Task Name referenced.
0xF905
Task address out of range.
0xFA05
Cannot replace I/O module.
0xFB05
Cannot clear I/O configuration.
0xFC05
I/O configuration is invalid.
0xFD05
Unable to perform auto configuration.
0xFE05
No privilege for attempted operation.
0xFF05
Service Request Error has been aborted.
EA1-TCL-M Hardware User Manual, 1st Ed., 12/09
®
A
Appendix A: Panel & PLC Error Code Tables