C-MORE EA1-TCL-M Hardware User Manual - 1–13
EA1-TCL-M Hardware User Manual, 1st Ed., 12/09
1–13
Chapter 1: Getting Started
1
®
Step 7 – Providing Power to the C-more 6” Color Micro-Graphic Panel
Power can be supplied to the C-more Micro-Graphic panel in one of three different ways.
1). The panel is powered by a 1 Amp @ 12-24 VDC power source in normal operation.
2). The C-more 6” Micro-Graphic panel can be powered during programming from the PC through
a USB Programming Cable such as USB-CBL-AB6. When powered from the PC, the panel will
operate in Low-Power mode and the screen brightness is diminished.
NPU 12 2 V 6 5W l s 2
NPU 12 2 V 6 5W l s 2
L T D
L T D
M17
M17
a e cod : **
a e cod : **
R 1
R 1
ADE N CH NA
ADE N CH NA
EA - 6C + se a num er
EA - 6C + se a num er
MODEL EA1- 6CL
MODEL EA1- 6CL
I D CO T Q.
I D CO T Q.
8
1
15
9
Supply to Panel
1 A @ 12 24 VDC
(10 8 26 4 VDC)
+
–
GND
Equipment
Ground
Recommended
DC Supply Fuse
750 mA fast acting,
ADC p/n AGC 75
Panel Powered from a DC Power Source - Wiring Diagram
NOTE: Recommended DC power supply to power the C-more Micro Graphic Panel, AutomationDirect Part No.
PSP24-024S or PSP24-024C.
Tightening Torque
Power supply wire connection
1 7 lb-in (0.2 Nm)
Required Wire Specification
Supported temperature
Over 60 °C
Wire Material
Copper
Wire Size
16 - 22 AWG