C-MORE EA1-TCL-M Hardware User Manual - Setting – Calibration

Setting – Calibration

With Calibration

highlighted, press

ENT [F5] to bring

up the first

calibration screen as

shown on the right.

Touch the “cross” in

the upper left corner

as accurately as you

can. When the

screen is touched,

the cross will move

to each corner and

finally to the center

of the screen. If the

touch points are

within the built-in

calibration

tolerance, the final

screen will allow

you to either save

and quit from the

calibration

procedure, or allow

you to retry. If the

points that were

touched are not

within the

calibration

tolerance, you will

be returned to the

first calibration

screen and will need

to start over.

ENT

SETTING 

1  Brightness              >

2  Touch/Key Beep    >

3  Cal bration              >

4  Clear User Memory

5  Reset to Factory Def

6  Hourglass               >

7  Rotation                  >

BAK  

UP  

DWN  

ENT  

NXT  

Press Cross Mark

Press F1 to Quit

Panel will not 

Communicate 

in this mode  

Press Cross Mark

Press F1 to Quit

Panel will not 

Communicate 

in this mode  

Press Cross Mark

Press F1 to Quit

F5 to Save & Quit 

F1 to Retry 

5

Chapter 5: System Setup Screens

5–9

EA1-TCL-M Hardware User Manual, 1st Ed., 12/09

®