C&S Electronics Computemp 5 Owner's Manual - Operating Instrucitons
OPERATING INSTRUCITONS
If you have not already done so, plug in the Computemp, this is accompanied by a chirp.
The unit is in the RUN MODE and is alternately displaying MAIN temperature, AUX
temperature and TIME. The three small lights changing with the digital read-out indicate
what is being displayed.
NOTE: For efficient operation, press the center of each command pad. On the top tier,
press directly on the words RUN and SET. On the lower tier, press the dot on the center of
each pad. Command pads can be pressed in any combination or sequence without harming
unit. Unit will automatically return to RUN MODE if no pads are pressed for one minute.
Before setting your Computemp for the first time, clear the temperature memory by
pressing LOW/SLOW and HIGH/FAST simultaneously.
TO SET TIME OF DAY
Repeatedly press SET until SET light at the top of the display is on. Repeatedly press
SELECT until TIME light is on. Use FAST or SLOW to set time of day. Return until to
RUN MODE by pressing RUN.
TO SET TIME ALARM
Repeatedly press SET until SET light at the top of the display is on. Repeatedly press
SELECT until TIME ALARM light is on. Use FAST or SLOW to set desired alarm time.
Return to RUN MODE by pressing RUN.
NOTE: for time of day and time alarm settings, be sure to observe AM light to insure
correct settings.
TO SET TEMP ALARM
Repeatedly press SET until SET light at the top of the display is on. Repeatedly press
SELECT until TEMP ALARM light is on. Use FAST or SLOW to set desired alarm
temperature. It is important to be aware of the fact that the temperature alarm sounds only
when temperature equals your alarm setting. Return to RUN MODE by pressing RUN.
TURNING ALARMS ON AND OFF
Repeatedly press SET until ALARM light at the top of the display is on. Then press
SELECT to enable or disable the TEMP and TIME alarms. When the TEMP alarm and
TIME alarm lights are off they will not sound. You can enable either or both of the alarms.
4