C&S Electronics Computemp 5 Owner's Manual - Probe Installation
of
8
PROBE INSTALLATION
Run the main sensor through a
window or any other convenient
topening. The ideal location for
he sensor is under the eave on
the north side of the building.
If this is not possible, avoid
locations that may be
abnormally warm for any reason
or where the sun can shine
directly on the sensor. Either of
these situations can cause
erroneous readings. The better
you plan the sensor location, the
better your Computemp will
perform. When you have chosen
the sensor location, mount the probe holder and snap the wire into the
holder within a few inches of the sensor. You may staple the probe wire in
place along the wall or eave, but take extreme care not to cut or pierce the
wire.
7