CAB ps800 Operator's Manual

Summary of ps800

  • Page 1

    Operator's manual made in germany present sensor ps800 / ps900 / ps1000

  • Page 2

    2 2 present sensor ps800 ps900 ps1000 edition: 02/2017 - art.-nr. 9009927 copyright this documentation as well as translation hereof are property of cab produkttechnik gmbh & co. Kg. The replication, conversion, duplication or divulgement of the whole manual or parts of it for other intentions than ...

  • Page 3: 1.1  Instructions

    3 1.1 instructions important information and instructions are designated as follows: ! Attention! Draws attention to potential risks of property damage or loss of quality. I note! Advices to make work routine easier or on important steps to be carried out. Handling instructions reference to chapter,...

  • Page 4: Product Description

    4 4 2 product description in peel-off mode print jobs will by split in cycles with the following steps: • a label will be printed, peeled-off from the liner and presented in the peel position. The print job stops. • the label will be removed from the peel position. Then depending on the printer sett...

  • Page 5: Attention!

    5 i note! Keep the original packaging for later transports. ! Attention! Damage and failure in function by dust, dirtiness and humidity.  use devices only in a clean and dry environment. 1 3 2 4 5 figure 1 mounting the present sensor  switch off the printer.  loosen screw (4).  remove cover (2)....

  • Page 6: Operation

    6 6 4 operation 4.1 preparation  insert labels or peel-off mode  operator's manual of the printer.  insert ribbon  operator's manual of the printer.  activate the peel-off mode in the software. In direct programming use the "p" command.  programming manual of the printer. Configure the peel-of...

  • Page 7: Printer Configuration

    7 5 printer configuration peel-off parameter  start menu.  select setup > peeling-off. Parameter meaning default peel-off position shift the position of the dispensed label relative to the dispensing edge. The setting can also be adjusted by the software. The settings of configuration and software...

  • Page 8

    8 8 6 licenses 6.1 reference to the eu declaration of conformity the present sensors ps800 / ps900 / ps1000 comply with the relevant fundamental regulations of the eu rules for safety and health: • directive 2014/30/eu relating to electromagnetic compatibility • directive 2011/65/eu on the restricti...