CAB ps800 Operator's Manual - Operation
6
6
4
Operation
4.1 Preparation
Insert labels or peel-off mode Operator's manual of the printer.
Insert ribbon Operator's manual of the printer.
Activate the peel-off mode in the software.
In direct programming use the "P" command.
Programming Manual of the printer.
Configure the peel-off parameters „5 Printer Configuration“.
i
Note!
The peel-off parameters are only accessible with a present sensor
installed.
4.2 Adjusting the Sensor on PS900
1 2
Figure 2 Adjusting the sensor
Loosen screw (2).
Move the sensor (1) sidewards.
Tighten screw (2).
4.3 Peel-off Operation
The present sensor is immediately ready for use.
Send a print job.
The first label will be printed and transported to the peel position.
Remove the label.
The next label will be printed and transported to the peel position.
i
Note!
Special operating modes using the I/O interface of the printer are
described in the
Configuration Manual of the printer.