CABASSE Stream 1 Owner's Manual - page 5
4
5
INSTALLATION RAPIDE
QUICK PLUG & PLAY
Installer votre Stream 1 à proximité d'une prise de courant, soit
couché, soit posé debout ou encore accroché au mur.
Prévoir un espace suffisant pour le cas échéant pouvoir poser
brièvement un smartphone NFC au milieu de la grille du Stream 1
et réaliser une liaison Bluetooth automatique.
Cet espace est aussi nécessaire au bon fonctionnement des
antennes Bluetooth et wifi.
Place the Stream 1 close to a mains plug, either lying, standing or
hanging, with enough available headroom above the NFC patch
for a smartphone and the use of instant Blutooth connection.
This headroom is also necessary for the optimum efficiency of the
Bluetooth and wifi antennas.
Avant la première utilisation : retirer la languette de protection qui dépasse du
couvercle.
Remplacement de la pile bouton type CR-2025:
retourner la télécommande, enlever le couvercle, enlever la pile usagée, insérer la pile
neuve, coté marquée "+" vers l'extérieur, remettre le couvercle.
Before first use: remove the battery protection tab to activate the battery.
Replacement of the CR-2025 type battery in the Stream remote
control: Insert your thumbnail under the clasp and press to
realease it, remove the rear lid, remove the old battery and
load the new battery properly with the “+” side on the
clasp side, put the rear cover back on.
3
Connecter l'alimentation externe au Stream 1, brancher
l'alimentation au secteur et basculer l'interrupteur marche/
arrêt sur "on". Stream 1 est opérationnel dès que la diode
9
s'allume.
NOTE : la fonction wifi de Stream 1 devient opérationnelle
lorsque la diode PWR (power) est passée du rouge au vert,
environ 40 secondes après la mise sous tension.
Connect the power supply to the Stream 1, plug it to the mains
and position the POWER ON/OFF switch on "ON". Stream 1 is
ready to play when the LED
9
turns on.
NOTE: the wifi mode of Stream 1 is available when the PWR
(Power) LED has turned from red to green, around 40 seconds
after powering on the Stream 1.
2
1
Une fois les connexions Bluetooth et Wi-Fi
activées (voir chapitres suivants), sélectionner
entre la source Bluetooth et la Wi-Fi avec la
touche
8
de la télécommande Stream:
- la LED bleue s'allume pour la source Bluetooth
- le LED orange pour la source Wi-fi.
Once the Bluetooth and Wi-Fi connections
activated, press the
8
key of the remote
control untl you get the requested source:
- The blue LED enlights for the Bluetooth source
- The orange LED enlights for the Wi-Fi.
4