Cabletron Systems Netlink FRX4000 Installation And Setup Manual

Manual is about: Frame Relay Access Products

Summary of Netlink FRX4000

  • Page 1

    Installation & setup guide the complete networking solution tm.

  • Page 2

    Cabletron systems reserves the right to make changes in specifications and other information con- tained in this document without prior notice. The reader should in all cases consult cabletron systems to determine whether any such changes have been made. The hardware, firmware, and/or software descr...

  • Page 3

    Site requirements environment: 32–104 o f (0-40 o c) and 5–95% humidity, non-condensing. An ac power outlet of the appropriate voltage (110–125/60 hz or 200–240 vac/50 hz) must be located within five feet of the device. For adequate air flow, allow at least four inches of clearance at the rear and a...

  • Page 4

    Figure 2 auxiliary console cabling - console port to async terminal figure 3 auxiliary console cable - console port to modem installation & setup guide 3 installing an frx4000 the customer and sales representative decide on the necessary hardware and software components at the time a frx4000 is orde...

  • Page 5

    Figure 4 attaching the rack-mounting brackets 4. Attach the frx4000 to the rack's mounting angles as shown in the next two figures. If mounting the device into a rack with eia-standard hole spacing (repeating pattern of 5/8"-5/8"-1/2"), make sure each mounting tab on the frx4000 is centered on a hol...

  • Page 6

    Tighten the retaining screws on each wan port cable connector and the console port cable connector. If attaching a thick ethernet cable to the aui port, note that the connector has a slide latch. Snap the latch over the posts on the cable connector to lock it in place. If the assembly is rack mounte...

  • Page 7

    Figure 9 port status display 10. Now you must configure the software from the auxiliary console. Records must be configured to identify the locations and operating param- eters of the frx4000 and its ports. Configuration of these records is doc- umented in the netlink frx4000/frx6000 user guide, whi...

  • Page 8

    Questions? If you have questions or problems, please contact cabletron systems technical support at: phone: 603-332-9400 fax: 603-337-3075 e-mail: support@ctron.Com installation & setup guide 9 document number 09-41-06-103-02 the complete networking solution tm.