,qvwdoodwlrq 6hwxs *xlgh the complete networking solution tm.
Cabletron systems reserves the right to make changes in specifications and other information con- tained in this document without prior notice. The reader should in all cases consult cabletron systems to determine whether any such changes have been made. The hardware, firmware, and/or software descr...
Overview of installation and setup when a netlink ™ frx6000 is ordered, the customer and sales representative decide on the required components (cards, cables, etc.). Cards and software are then installed before the node is shipped. This document describes the steps to be taken at the customer site ...
Figure 2 lan card connectors 3. Assuming the node will be mounted in a rack, it can be secured to slides, or set on a fixed or slide-out shelf. The node can also be mounted directly to the cabinet frame, but this makes access difficult. Do not support a rack-mounted node only in the front. It must b...
Dce cables have female connectors at the user end, and dte cables have male connectors. Configure the video device follow the appropriate procedure to configure the frx6000 to operate with an attached auxiliary console (ascii terminal) or vga monitor. A vga monitor may be necessary even if you are c...
6. When prompted for a terminal speed, type the line speed (in bits per second) of the attached terminal ( 1200, 2400 , or 4800 ) and press [enter] . 7. When asked: are you changing only the async console or lan adapter con- figuration? , press [y] . 8. You will be asked: how many lan cards have you...
Configure the token ring card if the node has a token ring card, it is configured for a speed of 16 mb/sec and utp (unshielded twisted pair) cable. If you wish to change either setting, follow this procedure: 1. Boot the node with a dos system disk. 2. At the a:> prompt, insert the smc superdisk, th...
Figure 8 main menu 3. From here, configure the database as described in the user guide, or, if there was some problem, go to "displaying boot-up information." displaying boot-up information as the node boots, screen information tracks the loading of rlps, verifies con- figuration file format, and di...
Document number 09-41-06-144-02 the complete networking solution tm.
