Cabletron Systems SmartSwitch 2200 Instruction Sheet - page 3
P/N 9032790-01
Page 3 of 4
4. To install a device with bottom mounting brackets, proceed as follows:
a.
Apply a thin layer of anti-oxidant to the paint-free areas where the brackets will be mounted. See Figure 4.
b. There are several mounting holes in the rackmount brackets and the bottom of the chassis so that each mounting
bracket may be adjusted forward or backward to mount the device further into, or out of the rack, depending on
the installation requirements. Position the rackmount brackets over the appropriate holes.
c.
Locate the four 6-32 x 1/4-inch flathead screws in the rackmount kit.
d. Attach the rackmount brackets to the bottom of the device using the four 6-32 x 1/4-inch flathead screws, as
shown in Figure 4.
Figure 4
Installing the Rackmount Brackets
e.
With the mounting brackets installed, position the device between the vertical frame members of the 19-inch
rack and fasten it securely with thread-forming mounting screws (user supplied) as shown in Figure 5.
Figure 5
Installing the Device in a Rack
f.
Proceed to the next section,
Connecting a Device to a 48/60 Vdc Power Source
.
!
CAUTION
Do not
use screws longer than 1/4 inch. Screws longer than 1/4 inch will damage the electronics in the
device.
TELCO
CONSOLE
RESET
COM
PWR
CPU
2H252-25R
2X 4X 6X 8X 10X 12X 14X 16X 18X 20X 22X 24X
1
2
3
4
5
6
7
8
9
10
15
16
21
22
23
24
11
12
19
20
17
18
13
14
LED
MODE
RX-TX
DPX-SPD
FAST ETHERNET WORKGROUP
SWITCH
Rackmount Brackets
Screws
25041-04
Paint-Free Area
Paint-Free Area
Screws
19-Inch Rack
25041-05
RESET
COM
PWR
CPU
2H252-25R
2X 4X 6X 8X 10X 12X 14X 16X 18X 20X 22X 24X
1
2
3
4
5
6
7
8
9
10
15
16
21
22
23
24
11
12
19
20
17
18
13
14
LED
MODE
RX-TX
DPX-SPD
FAST ETHERNET WORKGROUP SWITCH