Cabletron Systems WPIM-DDS Management Manual - 2.3
WPIM-DDS Configuration
WPIM-DDS Local Management Guide
2-7
PT#
Displays the application ports (bridge ports) available from the host
platform to the WAN. If the active protocol is PPP, Local Management
assigns only one application port per interface number (IF#). If the active
protocol is Frame Relay, Local Management assigns the available WAN
bridge ports from the host platform, one per DLCI.
The quantity of application ports for a Frame Relay network is
determined by the quantity of DLCIs assigned to that Interface. This is
determined either manually or by the Link Management Protocol.
IF#
Displays the Interface that is associated with the application port.
LID
Displays the Link Identifier. If the active protocol is Frame Relay, the
Data Link Connection Identifier is displayed. If the active protocol for
this interface is PPP, then PPP appears in this field.
STATE
Displays the status of the application port. If the active protocol is Frame
Relay, this field displays the status as Active, Inactive, or Invalid
(no LMI). If the active protocol is PPP, this field displays UP (active) or
DOWN (inactive).
2.3
WPIM-DDS CONFIGURATION
This section provides step-by-step instructions for connecting the
WPIM-DDS to a Digital Data Service circuit in a PPP or Frame Relay
environment. This example assumes the setup shown in Figure 2-3 using
two MicroMMAC hubs with WPIM-DDS modules installed in each
BRIM-W6.
Figure 2-3
WPIM-DDS Interface Configuration for PPP
Telco Cloud
MicroMMAC #2
with BRIM-W6
SITE #2
MicroMMAC #1
with BRIM-W6
SITE #1
1483_03
WPIM
DDS
WPIM
DDS