Cabletron Systems WPIM-DDS Management Manual - 2.3.1
Chapter 2: Local Management
2-8
WPIM-DDS Local Management Guide
The line configuration information shown in Table 2-1, must be supplied
by the service provider.
2.3.1
WPIM-DDS Physical Configuration
Begin the WPIM-DDS configuration by accessing the WAN Physical
Configuration screen (Figure 2-1) through Local Management. To access
the WAN Physical Configuration screen from the Setup screen, use the
arrow keys to highlight the WAN BRIM Setup option, then press
ENTER. The screen shown in Figure 2-1 appears. Proceed with the
following steps:
1. Use the arrow keys to highlight the [WPIM] field at the bottom of the
screen. Press the SPACE bar to select the WPIM being configured,
then press ENTER.
2. Use the arrow keys to highlight DDS Line Mode. Press the SPACE
bar to set the DDS Line Mode to DDS-PRI or DDS-CC, then press
ENTER.
3. Use the arrow keys to highlight DDS Tx Clock Source. Press the
SPACE bar to set to Loop, then press ENTER.
4. Use the arrow keys to highlight DDS Loopback. Press the SPACE bar
to set to NONE, then press ENTER.
5. Use the arrow keys to highlight the SAVE command. Then press
ENTER. The message “Save Done!” appears and Local Management
saves the changes to memory.
Access the WAN Interface Configuration screen (Figure 2-2) by using the
arrow keys to highlight the WAN INT CONFIG option, then press
ENTER.
Table 2-1
Telco Configuration Information
Configuration Information
Required By User
Configuration Information
Supplied By Service Provider
Clock Source
Telco provided or no clock source
Line Mode
Primary or Clear Channel
FR-LMP (Frame Relay Only)
Telco provided or user requested