Caffitaly System S06HS Instruction Manual

Other manuals for S06HS: Instruction Manual, Instruction Book

Summary of S06HS

  • Page 1

    Instruction manual imported by roasting australia holdings pty limited 11 hoyle avenue, castle hill, nsw 2154 phone: 02 9846 0307 e-mail: info@maranathaimport.Com.Au model s06hs only use with caffitaly system capsules tested safety emc.

  • Page 2: Instructions:

    Z • introduction 2 • safety warnings 3 • symbols guide 4 instructions: • machine components 5 • first time use 6 • correct use of the buttons 7 • dispensing beverages - using factory settings 8 • turning on the appliance 9 • dispensing hot water 9 • frothing / dispensing steam 10 • programming the q...

  • Page 3: Congratulations

    2. Congratulations on the purchase of your new caffitaly system s06hs machine. You can now savour your favourite hot beverages at any time, day or night with the caffitaly system s06hs by choosing one of the many compatible caffitaly system capsules available. With the added steam wand, you can enjo...

  • Page 4: Safety Warnings

    Z safety warnings if you do not comply with the operating instructions and safety warnings in this instruction manual, the machine may become dangerous to operate. Please ensure you keep this instruction manual in a safe place. Carefully read the following instructions before use. This way you will ...

  • Page 5: Safety Warnings - Continued

    • this appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Childr...

  • Page 6: Machine Components

    Z double espresso button 60ml (lit white) single espresso button 30ml (lit white) hot water/steam control lever indicator light orange=descale red=check system tea button -120ml (lit blue) hot water/ steam control lever lever for opening and closing capsule compartment dispensing spout (adjustable) ...

  • Page 7: First Time Use

    First time use please ensure you only use caffitaly system capsules which can be identified by the caffitaly logo. We recommend following these steps after not having used the machine for a long period of time. Continued on next page... >> 6. Only use with caffitaly system capsules fill the tank wit...

  • Page 8: First Time Use - Continued

    Z first time use - continued correct use of buttons single espresso button - 30ml (lit in white). Used for dispensing a single espresso shot. When in doubt follow the directions on the capsule box regarding required button use. Diagram 3: 7. Double espresso button - 60ml (lit in white). Use for disp...

  • Page 9

    Dispensing beverages - using factory settings maintenance tip: traces of the product just dispensed may remain in the circuit of the machine. Between uses, to ensure optimum product delivery, remove used capsule from machine and rinse by pressing double espresso button. Note: the quantity of beverag...

  • Page 10: Dispensing Hot Water

    Z turning on the appliance - daily use dispensing hot water to stop dispensing the hot water, return the control lever to its central position. Remove the container of hot water. Place a metal container or cup under the steam wand dispensing pipe. 1. Remember to clean the tube with a damp cloth afte...

  • Page 11: Frothing / Dispensing Steam

    Frothing / dispensing steam 10. Warning! During preparation there may be some brief splashes of hot water and the steam wand reaches very high temperatures - danger of scalding! The tube must only be handled using the *special rubber grip. Place a metal container or cup under steam wand spout. Turn ...

  • Page 12: Frothing / Dispensing Steam

    Z programming the quantity of beverage in a cup note: the quantity of coffee dispensed may be programmed, from a minimum of 30ml to a maximum of 250ml. Maintenance tip: after having prepared the milk, dispense a small amount of steam and hot water to clean the steam wand and wipe the steam wand down...

  • Page 13

    Programming the quantity of beverage in a cup ... Continued maintenance tip: between uses, to ensure optimum product delivery, remove the used capsule from the machine and rinse by pressing the double espresso button. Switch the machine on using the on/off switch. Wait for approx. 1 min. For the mac...

  • Page 14

    Z general operating indications indicator light blinks orange and then remains on without blinking, it is advisable to perform the descaling cycle. See page 15 for instructions. Descaling signal: heating: 13. When all the button lights continuously blink, the machine is warming up. (this will take a...

  • Page 15: Daily Maintenance

    Gently turn coffee dispensing spout clockwise by approx. 45 o until it comes to a stop, then remove. Remove top cover of dispensing spout and wash components in hot water. Steam wand pipe gently remove the steam wand tube from the machine pipe. Gently separate metal tube from rubber grip and wash th...

  • Page 16: Descaling Instructions

    Z descaling instructions begin with machine off. Raise the lever, ensure no capsule in machine. 1. Empty and rinse the used capsule drawer and drip tray. Lower lever to close capsule compartment. 2. Descaling signal: when the indicator light blinks orange and the machine emits 3 beeps, please perfor...

  • Page 17

    Descaling instructions - continued * warning: please carefully empty the used capsule drawer after the first dispensing cycle (dose) to prevent any water from overflowing during the descaling process. Water in the used capsule drawer will be hot. Risk of scalding. Continue onto the rinsing instructi...

  • Page 18

    Z descaling instructions - continued 9. Empty and rinse the used capsule drawer, the drip tray and the container & replace. 17 rinse water tank and fill it with still fresh drinking water to the max line. 1. 2. Place a container under the coffee dispensing spout (at least 600ml). Rinsing: 3. Press t...

  • Page 19: Changing The Gasket

    18. Locate the gasket that was supplied in the box. Raise the lever. 2. Changing the gasket close the lever. Remove the worn gasket. Insert the new gasket, ensuring that it fits snugly into place. Caution! If the gasket shows signs of wear, such as small cuts or cracks and warping, you can replace i...

  • Page 20

    Z restore original settings (reset) these instructions will allow you to reset the machine back to its original factory settings – helpful if you experience an issue with the machine, or you have changed the pour levels for example and cannot change them back to their original levels. If you try to ...

  • Page 21: Troubleshooting

    20. No coffee comes out. Indicator light blinks red . The coffee is not hot enough. (please note: the temperature when dispensing coffee is set at approx. 65 degrees.) coffee is being dispensed very slowly and is of poor quality. The indicator light is lit steadily in red . The lever cannot be lower...

  • Page 22: 02 9846 0307

    Z the milk is not frothing. Water in the capsule drawer. Coffee grinds in the cup. The steam is cutting out when frothing milk. Red indicator light is on. Resetting the machine is not working. If any of the above solutions are not correcting your problem or you have any further questions/enquiries, ...

  • Page 23: Technical Data

    Technical data all materials and objects in contact with food products comply with the requirements of european regulation 1935/2004. The appliance has been manufactured using high quality materials that can be reused or recycled. Dispose of the appliance in a suitable waste collection centre. See t...

  • Page 24: Www.Caffitalysystem.Com.Au

    For more information on the machine operation, available capsules and other useful hints and tips go to the caffitaly website: www.Caffitalysystem.Com.Au only use with caffitaly system capsules the unique caffitaly system capsule what sets us apart from the rest? Our unique filtered capsule design e...