Caffitaly System S06HS Instruction Manual - Troubleshooting
20.
No coffee comes out.
indicator light blinks
RED
.
The coffee is not hot
enough.
(Please note: the
temperature when
dispensing coffee is set at
approx. 65 degrees.)
Coffee is being
dispensed very slowly
and is of poor quality.
The indicator light is lit
steadily in
RED
.
The lever cannot be
lowered.
When a button is
pressed to dispense
coffee, the machine
starts and then stops
without dispensing any
or only a very small
amount of coffee.
- The used capsule drawer
is full
- Capsule stuck inside the
machine.
- Incorrect dispensing
quantity programming.
- Empty out the used capsule
drawer.
- Remove the used capsule.
- Reprogram the quantity
associated with that button.
- Refer to ‘Reprogramming the
‘Quantity of Beverage in a Cup’ on
Page 11.
- Cold cups / espresso
cups.
- Scale buildup in the
machine.
- The Tea button was used
with an Espresso capsule.
- Incorrect use of the Tea
button.
- Heating problems.
- Preheat cup.
- Descale machine as instructed
under ‘Descaling your Machine’
on Page 15.
- Use the Single and Double
Espresso buttons only for
dispensing coffee.
- Reset the machine using the
instructions on Page 19 and
ensure the Tea button is only used
for dispensing Tea.
- Contact Roasting Australia
Customer Service on
02 9846 0307.
- The water tank is empty.
- No water in the system.
- Capsule in the capsule
compartment.
- Fill the tank with fresh water.
Press the Double Espresso
button to refill the circuit. When
the buttons remain steadily lit,
the machine is ready for use.
- Press the Double Espresso
button to cycle water through
the system.
- Clear the capsule in the capsule
compartment. Press the Double
Espresso button to cycle water
through the system.
PROBLEM
CAUSE
SOLUTION