CalAmp ITC 220 User manual - page 100
ITC 220 Base Station, Locomotive & Wayside Radio Transceiver Field Service Guide PN 0046300120 Rev. A
| Page 94
Note: If you enter the wrong password, you see the message “INCORRECT PASSWORD.” If you are already logged
on, you see the message “ALREADY LOGGED ON.”
I.2 LOG OFF FROM THE TRANSCEIVER
After you log on to a transceiver, it will log you off automatically if it does not detect any activity from you for 10
minutes. You can also log off manually at any time.
To log off from a radio:
1. On the computer, open XtermW if it is not already running.
2. Click Send, click Command, and then type:
LOGOFF
3. Click OK or press Enter.
I.3 CHANGE YOUR TRANSCEIVER PASSWORD
Changing your password from the default or a password you have been using to a new password is a good way to
improve security on the transceiver. If you are not sure when to change your password, check with your company’s
established security procedures.
The requirements for a password are:
Passwords can consist of any alphanumeric characters (a, b, c,…, 1, 2, 3,…), plus the dash (–) character, in any
combination. For example, a password can consist of all letters, all numbers, or a combination of letters and
numbers and dash characters.
Passwords must be 3 to 30 characters.
Passwords are not case sensitive.
To change your password:
1. Log on to the transceiver.
2. In XtermW , click Send, click Command, and then type:
NEWPASSWORD,oldpassword,newpassword,newpassword
Where:
oldpassword is your current password
newpassword is your new password you want to change to
3. Click OK or press Enter.